How to repair garage door panel

With the right information at hand, garage door repair should not be an expensive endeavor. By following the following steps, you will be able to repair your broken garage panel within a very short time.

When placing orders from the garage door panels, ensure you get them from the manufacturer who made the garage door. Although garage doors look the same, they fit differently on doors.

Before you commence the repair, it is imperative to ensure safety. Make sure that all the power supplies for your automatic door are switched off.

Ensure that you remove the old panels by unscrewing them from the rollers. If the damaged panel is not on top, then start by removing the panel on top. Do this by sliding the top panel up. Slide the damaged one out.

Putting in a new panel entails a reversal of the steps identified. Simply slide in the new panel and attach it. You can then roll the top slide back to attach it. You can then open the garage door and reattach the spring. Let us have a look at all the parts of the garage door and what they do.

Don”t hesitate to call Top commercial Door Repair in Toronto for resolving your problems.

Brackets

These will help you hold the tracks to the wall. Tracks, therefore, allow your door to move back and forth. In some instances, these brackets get loose. You will have to fasten the screws effectively. In case the brackets get dented or damaged, you will have to pound them with a hammer and replace them.

Tracks

Ensure that the tracks are well aligned. There should be a horizontal track slanting towards the garage. Tracks on both sides should have the same height as the garage door walls. If they are not aligned, loosen them and adjust them into position and screw them back to perfection.

Rollers

With time, dust and dirt build-up on the rollers of your garage door. This will hinder the door from moving smoothly. Clean them and lubricate them with spray and powder. Keep doing this periodically to avoid these build-ups.

Hinges

The hinges of the door can also be easily damaged. As time goes, your hinges will become loose and could easily crack off. There are also those instances in which you will have to replace the off-center of the hinges. You can detect this by checking on the cracks on the wall or on the concrete of the foundation near the hinges. You will have to fill these to restore the functionality of your garage door.

Springs

You can now fix the tension on the door of the garage. You should then proceed to pull the cable through plate door. Re-tie the end.

By checking on all these parts of your garage door, you are bound to address any mechanical issue that might have been the cause of the problem. If any of the highlighted challenges is the cause of the malfunctioning, use the mitigation strategies identified. Your problem will have been solved aptly.